Norm

ASTM D7381 - 07 en

Standard Practice for Establishing Allowable Stresses for Round Timbers for Piles from Tests of Full-Size Material

  • Deze norm is ingetrokken sinds 01-04-2013

50,60 61,23 Incl BTW

Over deze norm

Status Ingetrokken
Aantal pagina's 6
Gepubliceerd op 01-09-2007
Taal Engels

1.1 This practice contains procedures for establishing allowable compression parallel to grain and bending stresses for round timbers used for piling, based on results from full-size tests.

Note 1

Allowable stresses for compression perpendicular to grain and shear properties are established in accordance with the provisions of Practice D 2899.

1.2 Stresses established under this practice are applicable to piles conforming to the size, quality, straightness, spiral grain, knot, shake and split provisions of Specification D 25.

1.3 A commentary on the practice is available from ASTM International.

1.4 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Details

ICS-code 79.040
Engelse titel Standard Practice for Establishing Allowable Stresses for Round Timbers for Piles from Tests of Full-Size Material
Vervangen door

Winkelwagen

Subtotaal:

Ga naar winkelwagen