Norm

ASTM D7381-07(2013)

Standard Practice for Establishing Allowable Stresses for Round Timbers for Piles from Tests of Full-Size Material

54,27

Over deze norm

Status Definitief
Aantal pagina's 7
Commissie D07.04
Gepubliceerd op 01-04-2013
Taal Engels

1.1 This practice contains procedures for establishing allowable compression parallel to grain and bending stresses for round timbers used for piling, based on results from full-size tests.

Note 1Allowable stresses for compression perpendicular to grain and shear properties are established in accordance with the provisions of Practice D2899.

1.2 Stresses established under this practice are applicable to piles conforming to the size, quality, straightness, spiral grain, knot, shake and split provisions of Specification D25.

1.3 A commentary on the practice is available from ASTM International.

1.4 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Details

ICS-code 79.040
Nederlandse titel Standard Practice for Establishing Allowable Stresses for Round Timbers for Piles from Tests of Full-Size Material
Engelse titel Standard Practice for Establishing Allowable Stresses for Round Timbers for Piles from Tests of Full-Size Material

Winkelwagen

Subtotaal:

Ga naar winkelwagen