Norm

ASTM D746 - 13 en

Standard Test Method for Brittleness Temperature of Plastics and Elastomers by Impact

  • Deze norm is ingetrokken sinds 01-12-2014

50,60 61,23 Incl BTW

Over deze norm

Status Ingetrokken
Aantal pagina's 7
Gepubliceerd op 01-06-2013
Taal Engels

1.1 This test method covers the determination of the temperature at which plastics and elastomers (as defined by Terminology D883) exhibit brittle failure under specified impact conditions. Two routine inspection and acceptance procedures are also provided.

Note 1When testing rubbers for impact brittleness use Test Method D2137. When testing plastic sheeting for impact brittleness, use Test Method D1790.

1.2 The values stated in SI units are to be regarded as the standard.

1.3 Due to the potential safety and environmental hazards associated with mercury-filled thermometers, the use of alternative temperature measuring devices (such as thermocouples and RTDs) is encouraged.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Note 2This test method and ISO 974 address the same subject matter, but differ in technical content.

Details

ICS-code 83.060
Engelse titel Standard Test Method for Brittleness Temperature of Plastics and Elastomers by Impact
Vervangt
Vervangen door

Winkelwagen

Subtotaal:

Ga naar winkelwagen