Norm

ASTM D7466/D7466M-10(2015)e1

Standard Test Method for Measuring Asperity Height of Textured Geomembranes

48,24

Over deze norm

Status Definitief
Aantal pagina's 4
Commissie D35.10
Gepubliceerd op 01-05-2015
Taal Engels

1.1 This test method covers a procedure to measure the asperity height of textured geomembranes.

1.2 This test method does not provide for measurement of the spacing between the asperities nor of the complete profile of the textured surface.

1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Details

ICS-code 59.080.70
Nederlandse titel Standard Test Method for Measuring Asperity Height of Textured Geomembranes
Engelse titel Standard Test Method for Measuring Asperity Height of Textured Geomembranes

Winkelwagen

Subtotaal:

Ga naar winkelwagen