Norm

ASTM D7471-09(2014)

Standard Specification for CPT-Fluoropolymer Molding and Extrusion Materials

48,24

Over deze norm

Status Definitief
Aantal pagina's 3
Commissie D20.15
Gepubliceerd op 01-03-2014
Taal Engels

1.1 This specification covers copolymers of chlorotrifluoroethylene, perfluoroalkoxy, and tetrafluoroethylene and are suitable for extrusion, compression, and injection molding.

1.2 This specification does not cover blended materials and does not cover recycled materials.

1.3 The values stated in SI units as detailed in IEEE/ASTM SI-10 are to be regarded as the standard. The values given in parentheses are for information only.

1.4 The following safety hazards caveat pertains only to the test method portion, Section 11, of this specification.This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Note 1There is no known ISO equivalent to this standard.

Details

ICS-code 83.080.20
Nederlandse titel Standard Specification for CPT-Fluoropolymer Molding and Extrusion Materials
Engelse titel Standard Specification for CPT-Fluoropolymer Molding and Extrusion Materials

Winkelwagen

Subtotaal:

Ga naar winkelwagen