Norm

ASTM D7606-11

Standard Practice for Sampling of High Pressure Hydrogen and Related Fuel Cell Feed Gases

54,27

Over deze norm

Status Definitief
Aantal pagina's 5
Commissie D03.14
Gepubliceerd op 01-03-2011
Taal Engels

1.1 This practice describes a hydrogen quality sampling apparatus (HQSA) and a procedure for the sampling of high pressure hydrogen at fueling nozzles of 35 or 70 Mega Pascal (MPa) fueling stations.

1.2 This practice does not include the analysis of the acquired sample. Applicable ASTM standards include but are not limited to test methods referenced in Section 2 of this practice.

1.3 This practice is not intended for sampling and measuring particulate matter in high pressure hydrogen. For procedures on sampling and measuring particulate matter see ASTM D7650 and D7651.

1.4 The values stated in SI units are standard. The values stated in inch-pounds are for information only.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Details

ICS-code 27.075
Nederlandse titel Standard Practice for Sampling of High Pressure Hydrogen and Related Fuel Cell Feed Gases
Engelse titel Standard Practice for Sampling of High Pressure Hydrogen and Related Fuel Cell Feed Gases

Winkelwagen

Subtotaal:

Ga naar winkelwagen