Norm

ASTM D7864/D7864M-15

Standard Test Method for Determining the Aperture Stability Modulus of Geogrids

54,27

Over deze norm

Status Definitief
Aantal pagina's 7
Commissie D35.01
Gepubliceerd op 01-06-2015
Taal Engels

1.1 This test method covers the procedure for measuring the “Aperture Stability Modulus” of a geogrid. (The terms “Secant Aperture Stability Modulus,” “Torsional Rigidity Modulus,” “In-plane Shear Modulus,” and “Torsional Stiffness Modulus” have been used in the literature to describe this same property.)

1.2 This test method is intended to determine the in-plane stability of a geogrid by clamping a center node and measuring the stiffness over an area of the geogrid. This test method is applicable for various types of geogrid.

1.3 This test method is intended to provide characteristic properties for design. The test method was developed for pavement and subgrade improvement calibrated design methods requiring input of aperture stability modulus.

1.4 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Details

Nederlandse titel Standard Test Method for Determining the Aperture Stability Modulus of Geogrids
Engelse titel Standard Test Method for Determining the Aperture Stability Modulus of Geogrids

Winkelwagen

Subtotaal:

Ga naar winkelwagen