Norm

ASTM D7868 - 13(2017) en

Standard Practice for Determining the Dry Fall (Fog) Properties of Protective Coatings

45,11 54,58 Incl BTW

Over deze norm

Status Definitief
Aantal pagina's 4
Gepubliceerd op 01-12-2017
Taal Engels

1.1 This practice covers a procedure for qualitatively evaluating the dry fall properties of coatings. The establishment of the test environment and the evaluation procedures are described.

1.2 This practice uses panels containing an automotive finish since these types of surfaces are often the primary concern relating to overspray damage. Panels coated with other systems may be used as collection surfaces when they are deemed to be more representative.

1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Details

ICS-code 87.040
Nederlandse titel Standard Practice for Determining the Dry Fall (Fog) Properties of Protective Coatings
Engelse titel Standard Practice for Determining the Dry Fall (Fog) Properties of Protective Coatings
Vervangt

Winkelwagen

Subtotaal:

Ga naar winkelwagen