Norm

ASTM D787 - 18 en

Standard Specification for Ethyl Cellulose Molding and Extrusion Compounds

44,68 54,06 Incl BTW

Over deze norm

Status Definitief
Aantal pagina's 4
Gepubliceerd op 01-04-2018
Taal Engels

1.1 This specification covers requirements for plasticized ethyl cellulose thermoplastic compounds suitable for injection molding and extrusion. It does not include special materials compounded for special applications.

1.2 The values stated in SI units are to be regarded as standard. The English values given are for information only.

1.3 The following precautionary statement pertains only to the Test Methods portion, Section 9 of this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

Note 1: There is no known ISO equivalent to this specification.

1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Details

ICS-code 83.140.99
Engelse titel Standard Specification for Ethyl Cellulose Molding and Extrusion Compounds
Vervangt

Winkelwagen

Subtotaal:

Ga naar winkelwagen