Norm

ASTM D7951-17

Standard Specification for Disproportionation (TDP) Toluene

45,14

Over deze norm

Status Definitief
Aantal pagina's 2
Commissie D16.01
Gepubliceerd op 01-06-2017
Taal Engels

1.1 This specification covers Disproportionation (TDP) toluene.

1.2 The following applies to all specified limits in this specification: for purposes of determining conformance with this specification, an observed value or a calculated value shall be rounded off “to the nearest unit” in the last right-hand digit used in expressing the specification limit, in accordance with the rounding-off method of Practice E29.

1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.4 Consult current OSHA regulations, supplier’s Safety Data Sheets, and local regulations for all materials used in this specification.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Details

ICS-code 71.040.50
71.080.15
Nederlandse titel Standard Specification for Disproportionation (TDP) Toluene
Engelse titel Standard Specification for Disproportionation (TDP) Toluene

Winkelwagen

Subtotaal:

Ga naar winkelwagen