Norm

ASTM D8004-15

Standard Test Method for Fuel Dilution of In-Service Lubricants Using Surface Acoustic Wave Sensing

54,27

Over deze norm

Status Definitief
Aantal pagina's 6
Commissie D02.96.02
Gepubliceerd op 01-10-2015
Taal Engels

1.1 This test method describes a means for determining the amount of fuel dilution present in an in-service lubricant. This is achieved by drawing into a surface acoustic wave (SAW) sensor vapor from the lubricant. Fuel vapor will be absorbed by the SAW sensor’s polymer coating. The amount of absorbance is then related to fuel content in the lubricant.

1.2 The range of fuel dilution capable of being measured by the test method is from 0.1 % to 10.0 % by mass fuel dilution.

1.3 This test method is specifically tailored to determining the fuel dilution of in-service lubricants, including newly utilized lubricants. The method is applicable to contamination with diesel, gasoline, and jet fuels.

1.4 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.See Section 9.

Details

Nederlandse titel Standard Test Method for Fuel Dilution of In-Service Lubricants Using Surface Acoustic Wave Sensing
Engelse titel Standard Test Method for Fuel Dilution of In-Service Lubricants Using Surface Acoustic Wave Sensing

Winkelwagen

Subtotaal:

Ga naar winkelwagen