Over deze norm
1.1 This test method provides a laboratory technique for determining air leakage in low-sloped membrane roof assemblies under specified negative air pressures differences.
1.2 This test method is intended to measure air leakage of a roof assembly with rooftop penetrations.
1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
|Nederlandse titel||Standard Test Method for Quantification of Air Leakage in Low-Sloped Membrane Roof Assemblies|
|Engelse titel||Standard Test Method for Quantification of Air Leakage in Low-Sloped Membrane Roof Assemblies|