Norm

ASTM D887-13

Standard Practices for Sampling Water-Formed Deposits

54,27

Over deze norm

Status Definitief
Aantal pagina's 8
Commissie D19.03
Gepubliceerd op 01-01-2013
Taal Engels

1.1 These practices cover the sampling of water-formed deposits for chemical, physical, biological, or radiological analysis. The practices cover both field and laboratory sampling. It also defines the various types of deposits. The following practices are included:

 

Sections

Practice A—Sampling Water-Formed Deposits From Tubing
 of Steam Generators and Heat Exchangers

8 to 10

Practice B—Sampling Water-Formed Deposits From Steam
 Turbines

11 to 14


1.2 The general procedures of selection and removal of deposits given here can be applied to a variety of surfaces that are subject to water-formed deposits. However, the investigator must resort to his individual experience and judgment in applying these procedures to his specific problem.

1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. See Section 7, 9.8, 9.8.4.6, and 9.14 for specific hazards statements.

Details

ICS-code 13.060.30
Nederlandse titel Standard Practices for Sampling Water-Formed Deposits
Engelse titel Standard Practices for Sampling Water-Formed Deposits

Winkelwagen

Subtotaal:

Ga naar winkelwagen