Norm

ASTM D893-14

Standard Test Method for Insolubles in Used Lubricating Oils

54,27

Over deze norm

Status Definitief
Aantal pagina's 5
Commissie D02.06
Gepubliceerd op 01-05-2014
Taal Engels

1.1 This test method covers the determination of pentane and toluene insolubles in used lubricating oils.

1.2 Procedure A  covers the determination of insolubles without the use of coagulant in the pentane. It provides an indication of the materials that can readily be separated from the oil-solvent mixtures by centrifuging.

1.3 Procedure B  covers the determination of insolubles in oils containing detergents and employs a coagulant for both the pentane and toluene insolubles. In addition to the materials separated by using Procedure A, this coagulation procedure separates some finely divided materials that may be suspended in the oil.

Note 1Results obtained by Procedures A and B should not be compared since they usually give different values. The same procedure should be employed when comparing values obtained periodically on an oil in use or when comparing results determined by two or more laboratories.

1.4 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific warning statements, see Section 7 and 9.1.1.

Details

ICS-code 75.100
Nederlandse titel Standard Test Method for Insolubles in Used Lubricating Oils
Engelse titel Standard Test Method for Insolubles in Used Lubricating Oils

Winkelwagen

Subtotaal:

Ga naar winkelwagen