Norm

ASTM D957 - 06 en

Standard Practice for Determining Surface Temperature of Molds for Plastics

  • Deze norm is ingetrokken sinds 15-11-2012

45,11 54,58 Incl BTW

Over deze norm

Status Ingetrokken
Aantal pagina's 2
Gepubliceerd op 01-09-2006
Taal Engels

1.1 This practice is intended for determining the temperature at a specified point or points on the surface of the cavity and base of a mold for plastics. By determining the temperature at as many points as deemed necessary, the overall temperature condition of the surface can be determined.

1.2 The values stated in SI units are to be regarded as standard. The values in brackets are given for information only.

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Note 1

There is no similar ISO standard.

Details

ICS-code 83.200
Engelse titel Standard Practice for Determining Surface Temperature of Molds for Plastics
Vervangen door

Winkelwagen

Subtotaal:

Ga naar winkelwagen