Norm

ASTM D968-15

Standard Test Methods for Abrasion Resistance of Organic Coatings by Falling Abrasive

54,27

Over deze norm

Status Definitief
Aantal pagina's 5
Commissie D01.23
Gepubliceerd op 01-06-2015
Taal Engels

1.1 These test methods cover the determination of the resistance of organic coatings to abrasion produced by abrasive falling onto coatings applied to a plane rigid surface, such as a metal or glass panel.

1.2 Two test methods based on different abrasives are covered as follows:

 

Sections

Method A—Falling Sand Abrasion Test

6 – 13

Method B—Falling Silicon Carbide Abrasion Test

14 – 21

1.3 These methods should be restricted to testing in only one laboratory when numerical values are used because of the poor reproducibility of the methods (see 13.1.2 and 21.1.2). Interlaboratory agreement is improved significantly when ranking is used in place of numerical values.

1.4 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

1.5 This standard does not purport to address the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Details

ICS-code 25.220.60
Nederlandse titel Standard Test Methods for Abrasion Resistance of Organic Coatings by Falling Abrasive
Engelse titel Standard Test Methods for Abrasion Resistance of Organic Coatings by Falling Abrasive

Winkelwagen

Subtotaal:

Ga naar winkelwagen