Norm

ASTM E10 - 18 en

Standard Test Method for Brinell Hardness of Metallic Materials

73,73 89,21 Incl BTW

Over deze norm

Status Definitief
Aantal pagina's 33
Gepubliceerd op 01-07-2018
Taal Engels

1.1 This test method covers the determination of the Brinell hardness of metallic materials by the Brinell indentation hardness principle. This standard provides the requirements for a Brinell testing machine and the procedures for performing Brinell hardness tests.

1.2 This test method includes requirements for the use of portable Brinell hardness testing machines that measure Brinell hardness by the Brinell hardness test principle and can meet the requirements of this test method, including the direct and indirect verifications of the testing machine. Portable Brinell hardness testing machines that cannot meet the direct verification requirements and can only be verified by indirect verification requirements are covered in Test Method E110.

1.3 This standard includes additional requirements in the following annexes:

Verification of Brinell Hardness Testing Machines

Annex A1

Brinell Hardness Standardizing Machines

Annex A2

Standardization of Brinell Hardness Indenters

Annex A3

Standardization of Brinell Hardness Test Blocks

Annex A4

1.4 This standard includes nonmandatory information in the following appendixes that relates to the Brinell hardness test:

Table of Brinell Hardness Numbers

Appendix X1

Examples of Procedures for Determining
Brinell Hardness Uncertainty

Appendix X2

1.5 At the time the Brinell hardness test was developed, the force levels were specified in units of kilograms-force (kgf). Although this standard specifies the unit of force in the International System of Units (SI) as the Newton (N), because of the historical precedent and continued common usage of kgf units, force values in kgf units are provided for information and much of the discussion in this standard refers to forces in kgf units.

1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.7 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Details

ICS-code 77.040.10
Engelse titel Standard Test Method for Brinell Hardness of Metallic Materials
Vervangt

Winkelwagen

Subtotaal:

Ga naar winkelwagen