ASTM E1032-12

Standard Test Method for Radiographic Examination of Weldments


Over deze norm

Status Definitief
Aantal pagina's 6
Commissie E07.01
Gepubliceerd op 15-06-2012
Taal Engels

1.1 This test method provides a uniform procedure for radiographic examination of weldments using industrial radiographic film. Requirements expressed in this method are intended to control the quality of the radiographic images and are not intended for controlling acceptability or quality of welds.

1.2 The radiographic extent, the quality level, and the acceptance criteria to be applied shall be specified in the contract, purchase order, product specification, or drawings.

1.3 The radiographic techniques stated herein provide adequate assurance for defect detectability; however, it is recognized that, for special applications, specific techniques using more or less stringent requirements may be required than those specified. In these cases, the use of alternative radiographic techniques shall be as agreed upon between purchaser and supplier (also see Section 4).

1.4 The values stated in inch-pound units are to be regarded as standard.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. (For more specific safety precautionary information, see Section 7.)


ICS-code 25.160.40
Nederlandse titel Standard Test Method for Radiographic Examination of Weldments
Engelse titel Standard Test Method for Radiographic Examination of Weldments



Ga naar winkelwagen