Norm

ASTM E1077-14

Standard Test Methods for Estimating the Depth of Decarburization of Steel Specimens

54,27

Over deze norm

Status Definitief
Aantal pagina's 10
Commissie E04.14
Gepubliceerd op 01-01-2014
Taal Engels

1.1 These test methods cover procedures for estimating the depth of decarburization of steels irrespective of the composition, matrix microstructure, or section shape. The following basic procedures may be used:

1.1.1 Screening methods.

1.1.2 Microscopical methods.

1.1.3 Microindentation hardness methods.

1.1.4 Chemical analysis methods.

1.2 In case of a dispute, the rigorous quantitative or lineal analysis method (see 7.3.5 and 7.3.6) shall be the referee method. These methods can be employed with any cross-sectional shape. The chemical analytical methods generally reveal a greater depth of decarburization than the microscopical methods but are limited to certain simple shapes and by availability of equipment. These techniques are generally reserved for research studies. The microindentation hardness method is suitable for accurate measurements of hardened structures with relatively homogeneous microstructures.

1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Details

ICS-code 77.080.20
Nederlandse titel Standard Test Methods for Estimating the Depth of Decarburization of Steel Specimens
Engelse titel Standard Test Methods for Estimating the Depth of Decarburization of Steel Specimens

Winkelwagen

Subtotaal:

Ga naar winkelwagen