Norm

ASTM E1114-09(2014)

Standard Test Method for Determining the Size of Iridium-192 Industrial Radiographic Sources

54,27

Over deze norm

Status Definitief
Aantal pagina's 5
Commissie E07.01
Gepubliceerd op 01-10-2014
Taal Engels

1.1 This test method covers the determination of the size of an Iridium-192 radiographic source. The determination is based upon measurement of the image of the Iridium metal source in a projection radiograph of the source assembly and comparison to the measurement of the image of a reference sample in the same radiograph.

1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Details

ICS-code 19.100
Nederlandse titel Standard Test Method for Determining the Size of Iridium-192 Industrial Radiographic Sources
Engelse titel Standard Test Method for Determining the Size of Iridium-192 Industrial Radiographic Sources

Winkelwagen

Subtotaal:

Ga naar winkelwagen