Norm

ASTM E1155-14

Standard Test Method for Determining FF Floor Flatness and FL Floor Levelness Numbers

54,27

Over deze norm

Status Definitief
Aantal pagina's 8
Commissie E06.21
Gepubliceerd op 01-04-2014
Taal Engels

1.1 This test method covers a quantitative method of measuring floor surface profiles to obtain estimates of the floor's characteristic FF Flatness and FL Levelness Face Floor Profile Numbers (F-Numbers) using the inch-pound system of units.

Note 1: A complete metric companion to Test Method E1155 has been developed, Test Method E1155M; therefore, no metric equivalents are shown in this test method.

1.2 The text of this test method references notes and footnotes that provide explanatory material. These notes and footnotes (excluding those in tables and figures) shall not be considered as requirements of this test method.

1.3 The values stated in inch-pound units are to be regarded as standard. No other units of measurement are included in this standard.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Details

ICS-code 91.060.30
Nederlandse titel Standard Test Method for Determining FF Floor Flatness and FL Floor Levelness Numbers
Engelse titel Standard Test Method for Determining FF Floor Flatness and FL Floor Levelness Numbers

Winkelwagen

Subtotaal:

Ga naar winkelwagen