Over deze norm
1.1 These test methods describe procedures for determining the static axial tensile and shear strengths of power-actuated fasteners installed in structural members made of concrete, concrete masonry, and steel.
1.2 These test methods are intended for use with fasteners that are installed perpendicular to a plane surface of the structural member.
1.3 Tests for combined tension and shear, fatigue, dynamic, and torsional load resistance are not covered.
1.4 The values stated in SI units are to be regarded as standard. The values given in parentheses are mathematical conversions to inch-pound units that are provided for information only and are not considered standard.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. Specific hazard statements are given in Section .
1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
|Nederlandse titel||Standard Test Methods for Strength of Power-Actuated Fasteners Installed in Structural Members|
|Engelse titel||Standard Test Methods for Strength of Power-Actuated Fasteners Installed in Structural Members|