Norm

ASTM E1211/E1211M-12

Standard Practice for Leak Detection and Location Using Surface-Mounted Acoustic Emission Sensors

54,27

Over deze norm

Status Definitief
Aantal pagina's 5
Commissie E07.04
Gepubliceerd op 15-06-2012
Taal Engels

1.1 This practice describes a passive method for detecting and locating the steady state source of gas and liquid leaking out of a pressurized system. The method employs surface-mounted acoustic emission sensors (for non-contact sensors see Test Method E1002), or sensors attached to the system via acoustic waveguides (for additional information, see Terminology E1316), and may be used for continuous in-service monitoring and hydrotest monitoring of piping and pressure vessel systems. High sensitivities may be achieved, although the values obtainable depend on sensor spacing, background noise level, system pressure, and type of leak.

1.2 UnitsThe values stated in either SI units or inch-pound units are to be regarded as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standards.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Details

ICS-code 17.140.01
Nederlandse titel Standard Practice for Leak Detection and Location Using Surface-Mounted Acoustic Emission Sensors
Engelse titel Standard Practice for Leak Detection and Location Using Surface-Mounted Acoustic Emission Sensors

Winkelwagen

Subtotaal:

Ga naar winkelwagen