Norm

ASTM E1214-11e1

Standard Guide for Use of Melt Wire Temperature Monitors for Reactor Vessel Surveillance

43,06

Over deze norm

Status Definitief
Aantal pagina's 3
Commissie E10.02
Gepubliceerd op 01-07-2011
Taal Engels

1.1 This guide describes the application of melt wire temperature monitors and their use for reactor vessel surveillance of light-water power reactors as called for in Practices E185 and E2215.

1.2 The purpose of this guide is to recommend the selection and use of the common melt wire technique where the correspondence between melting temperature and composition of different alloys is used as a passive temperature monitor. Guidelines are provided for the selection and calibration of monitor materials; design, fabrication, and assembly of monitor and container; post-irradiation examinations; interpretation of the results; and estimation of uncertainties.

1.3 The values stated in SI units are to be regarded as standard. The values given in parentheses are mathematical conversions to inch-pound units that are provided for information only and are not considered standard.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. (See Note 1.)

1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Details

ICS-code 27.120.20
Nederlandse titel Standard Guide for Use of Melt Wire Temperature Monitors for Reactor Vessel Surveillance
Engelse titel Standard Guide for Use of Melt Wire Temperature Monitors for Reactor Vessel Surveillance

Winkelwagen

Subtotaal:

Ga naar winkelwagen