Norm

ASTM E1274-03(2012)

Standard Test Method for Measuring Pavement Roughness Using a Profilograph

48,24

Over deze norm

Status Definitief
Aantal pagina's 4
Commissie E17.31
Gepubliceerd op 01-12-2012
Taal Engels

1.1 This test method covers the measurement of pavement roughness using an articulated multi-wheeled profilograph at least 23 ft (7 m) long (Fig. 1 is typical).

 Typical Profilograph
FIG. 1 Typical Profilograph

1.2 This test method utilizes a surface record made by moving the profilograph longitudinally over the pavement at less than 3 mph (5 km/hr). The record is analyzed to determine the rate of roughness and to identify bumps that exceed a specified threshold.

1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.4 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. See Section 6 for specific hazard statement.

Details

ICS-code 93.080.20
Nederlandse titel Standard Test Method for Measuring Pavement Roughness Using a Profilograph
Engelse titel Standard Test Method for Measuring Pavement Roughness Using a Profilograph

Winkelwagen

Subtotaal:

Ga naar winkelwagen