Norm

ASTM E1602-03(2010)e1

Standard Guide for Construction of Solid Fuel Burning Masonry Heaters

54,27

Over deze norm

Status Definitief
Aantal pagina's 9
Commissie E06.54
Gepubliceerd op 01-04-2010
Taal Engels

1.1 This guide covers the design and construction of solid fuel burning masonry heaters. It provides dimensions for site constructed masonry heater components and clearances that have been derived by experience and found to be consistent with the safe installation of those masonry heaters.

1.2 Values given in SI units are to be regarded as standard. Inch/pound units may be rounded (see ). All dimensions are nominal unless specifically stated otherwise. All clearances listed in this guide are actual dimensions.

1.3 This guide applies to the design and construction of masonry heaters built on-site with the components and materials specified herein. It does not apply to the construction/installation requirements for component systems that have been safety tested and listed. The requirements for listed masonry heater systems are specified in the manufacturer's installation instructions.

1.4 The design and construction of solid fuel burning masonry heaters shall comply with applicable building codes.

Details

ICS-code 25.180.20
Nederlandse titel Standard Guide for Construction of Solid Fuel Burning Masonry Heaters
Engelse titel Standard Guide for Construction of Solid Fuel Burning Masonry Heaters

Winkelwagen

Subtotaal:

Ga naar winkelwagen