ASTM E164-13

Standard Practice for Contact Ultrasonic Testing of Weldments


Over deze norm

Status Definitief
Aantal pagina's 24
Commissie E07.06
Gepubliceerd op 01-06-2013
Taal Engels

1.1 This practice covers techniques for the ultrasonic A-scan examination of specific weld configurations joining wrought ferrous or aluminum alloy materials to detect weld discontinuities (see Note 1). The reflection method using pulsed waves is specified. Manual techniques are described employing contact of the search unit through a couplant film or water column.

1.2 This practice utilizes angle beams or straight beams, or both, depending upon the specific weld configurations. Practices for special geometries such as fillet welds and spot welds are not included. The practice is intended to be used on thicknesses of 0.250 to 8 in. (6.4 to 203 mm).

Note 1This practice is based on experience with ferrous and aluminum alloys. Other metallic materials can be examined using this practice provided reference standards can be developed that demonstrate that the particular material and weld can be successfully penetrated by an ultrasonic beam.
Note 2For additional pertinent information see Practice E317, Terminology E1316, and Practice E587.

1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.4  This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.


ICS-code 25.160.40
Nederlandse titel Standard Practice for Contact Ultrasonic Testing of Weldments
Engelse titel Standard Practice for Contact Ultrasonic Testing of Weldments



Ga naar winkelwagen