Norm

ASTM E1925-10

Specifiction for Engineering and Design Criteria for Rigid Wall Relocatable Structures

61,51

Over deze norm

Status Definitief
Aantal pagina's 13
Commissie E06.53
Gepubliceerd op 01-10-2010
Taal Engels

1.1 This specification covers engineering and design criteria required for the development of rigid wall relocatable structures (RWRS) and shall be applied to the design of expandable and nonexpandable RWRSs. This specification applies to present engineering and design requirements for effective RWRSs that are operable in a variety of environments without degradation and are capable of all specified transport modes. This specification shall be applied to the design of expandable and nonexpandable RWRSs. This specification is a conversion of a military standard that was approved by all departments and agencies of the Department of Defense.

1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.3 The following safety hazards caveat pertains only to the test required portion, Section 10, of this specification. This specification does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this specification to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Details

ICS-code 91.060.10
Nederlandse titel Specifiction for Engineering and Design Criteria for Rigid Wall Relocatable Structures
Engelse titel Specifiction for Engineering and Design Criteria for Rigid Wall Relocatable Structures

Winkelwagen

Subtotaal:

Ga naar winkelwagen