Norm

ASTM E2024/E2024M-11

Standard Practice for Atmospheric Leaks Using a Thermal Conductivity Leak Detector

48,24

Over deze norm

Status Definitief
Aantal pagina's 3
Commissie E07.08
Gepubliceerd op 01-07-2011
Taal Engels

1.1 This practice covers procedures for detecting the sources of gas leaking at the rate of 1 × 105 Pa m3/s (1 × 104 standard cm3/s) or greater. The tests may be conducted on any object that can be pressurized with a tracer gas that is detectable by a thermal conductivity detector. The test sensitivity will vary widely depending on the tracer gas used.

1.2 UnitsThe values stated in either SI or std-cc/sec units are to be regarded separately as standard. The values stated in each system may not be exact equivalents: therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Details

ICS-code 19.100
Nederlandse titel Standard Practice for Atmospheric Leaks Using a Thermal Conductivity Leak Detector
Engelse titel Standard Practice for Atmospheric Leaks Using a Thermal Conductivity Leak Detector

Winkelwagen

Subtotaal:

Ga naar winkelwagen