Norm

ASTM E2261/E2261M-17

Standard Practice for Examination of Welds Using the Alternating Current Field Measurement Technique

54,91

Over deze norm

Status Definitief
Aantal pagina's 15
Commissie E07.07
Gepubliceerd op 01-06-2017
Taal Engels

1.1 This practice describes procedures to be followed during alternating current field measurement examination of welds for baseline and service-induced surface breaking discontinuities.

1.2 This practice is intended for use on welds in any metallic material.

1.3 This practice does not establish weld acceptance criteria.

1.4 Units—The values stated in either inch-pound units or SI units are to be regarded separately as standard. The values stated in each system might not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the standard.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Details

ICS-code 25.160.40
Nederlandse titel Standard Practice for Examination of Welds Using the Alternating Current Field Measurement Technique
Engelse titel Standard Practice for Examination of Welds Using the Alternating Current Field Measurement Technique

Winkelwagen

Subtotaal:

Ga naar winkelwagen