Norm

ASTM E2298-15

Standard Test Method for Instrumented Impact Testing of Metallic Materials

54,27

Over deze norm

Status Definitief
Aantal pagina's 9
Commissie E28.07
Gepubliceerd op 01-10-2015
Taal Engels

1.1 This test method establishes the requirements for performing instrumented Charpy V-Notch (CVN) and instrumented Miniaturized Charpy V-Notch (MCVN) impact tests on metallic materials. This method, which is based on experience developed testing steels, provides further information (in addition to the total absorbed energy) on the fracture behavior of the tested materials. Minimum requirements are given for measurement and recording equipment such that similar sensitivity and comparable total absorbed energy measurements to those obtained in Test Methods E23 and E2248 are achieved.

1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Details

ICS-code 77.040.10
Nederlandse titel Standard Test Method for Instrumented Impact Testing of Metallic Materials
Engelse titel Standard Test Method for Instrumented Impact Testing of Metallic Materials

Winkelwagen

Subtotaal:

Ga naar winkelwagen