Norm

ASTM E2510-07(2013)

Standard Test Method for Torque Calibration or Conformance of Rheometers

48,24

Over deze norm

Status Definitief
Aantal pagina's 4
Commissie E37.08
Gepubliceerd op 01-03-2013
Taal Engels

1.1 This test method describes the calibration or performance conformance for the torque signal generated by commercial or custom-built rheometers. The specific range of the test depends upon the torque range of the rheometer.

1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.3 There is no ISO standard equivalent to this test method.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Details

ICS-code 17.060
Nederlandse titel Standard Test Method for Torque Calibration or Conformance of Rheometers
Engelse titel Standard Test Method for Torque Calibration or Conformance of Rheometers

Winkelwagen

Subtotaal:

Ga naar winkelwagen