Norm

ASTM E2918-13

Standard Test Method for Performance Validation of Thermomechanical Analyzers

54,27

Over deze norm

Status Definitief
Aantal pagina's 7
Commissie E37.10
Gepubliceerd op 01-04-2013
Taal Engels

1.1 This test method provides procedures for validating temperature and length change measurements of thermomechanical analyzers (TMA) and analytical methods based upon the measurement of temperature and length change. Performance parameters include temperature repeatability, linearity and bias; and dimension change repeatability, detection limit, quantitation limit, linearity and bias.

1.2 Validation of apparatus performance and analytical methods is a necessary requirement for quality initiatives. Results may also be used for legal purposes.

1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Details

ICS-code 17.200.20
Nederlandse titel Standard Test Method for Performance Validation of Thermomechanical Analyzers
Engelse titel Standard Test Method for Performance Validation of Thermomechanical Analyzers

Winkelwagen

Subtotaal:

Ga naar winkelwagen