Norm

ASTM E2975-15

Standard Test Method for Calibration of Concentric Cylinder Rotational Viscometers

48,24

Over deze norm

Status Definitief
Aantal pagina's 4
Commissie E37.08
Gepubliceerd op 01-09-2015
Taal Engels

1.1 This test method describes the calibration (or performance validation) of rotational viscometers in which the rotational element is immersed in the test fluid under ambient temperature conditions. It is not intended for cone-and-plate or parallel plate viscometers.

1.2 Calibration shall be performed with Newtonian reference materials using experimental conditions, such as temperature, viscosity range and shear rate (rotational speed), as close as practical to those to be used for measurement of test specimens.

1.3 The values stated in SI units are to be regarded as standard. The values given in parentheses are mathematical conversions to inch-pound units that are provided for information only and are not considered standard.

1.3.1 Common viscosity units of Poise (P) are related to the SI units by the equivalency 1 cP = 1 mPa·s.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Details

ICS-code 17.060
Nederlandse titel Standard Test Method for Calibration of Concentric Cylinder Rotational Viscometers
Engelse titel Standard Test Method for Calibration of Concentric Cylinder Rotational Viscometers

Winkelwagen

Subtotaal:

Ga naar winkelwagen