ASTM E3090/E3090M - 17 en

Standard Test Methods for Strength Properties of Metal Ceiling Suspension Systems

  • Deze norm is ingetrokken sinds 01-11-2018

57,09 62,23 Incl BTW

Over deze norm

Status Ingetrokken
Aantal pagina's 9
Gepubliceerd op 01-04-2017
Taal Engels

1.1 These test methods cover metal ceiling suspension systems used primarily to support acoustical tile, acoustical lay-in panels, or suspended T-bar type ceiling systems.

1.2 These test methods cover the determination of strength properties of suspended ceiling grid system components as follows:



Load Carrying Capacity


Connection Strength in Tension

5.2.2; 5.2.4

Connection Strength in Compression

5.2.3; 5.2.5

Wire Pullout Resistance


1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.4 The following safety hazards caveat pertains only to the test methods described in this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.


ICS-code 91.120.20
Engelse titel Standard Test Methods for Strength Properties of Metal Ceiling Suspension Systems
Vervangen door



Ga naar winkelwagen