Over deze norm
1.1 This specification defines the minimum requirements for agencies engaged in any of the following:
(a) Inspection of specified methods and materials used in construction,
(b) Special Inspection, and
(c) Testing of materials used in construction.
1.2 Criteria are provided for assessing the competence of an agency to properly perform designated inspections, tests, or Special Inspection services. This specification establishes essential characteristics pertaining to the organization, management, personnel, facilities, quality systems, responsibilities, duties, inspection and testing methods, records, and reports of the agency. This specification may be supplemented by more specific criteria and requirements, if required.
1.2.1 This specification specifically addresses factors relevant to an agency’s ability to produce precise, accurate test data or determine the conformity of construction activities and materials used in construction with regulations, codes, standards, and approved project plans and specifications containing the requirements against which the inspection or test, or both, will be performed. Specific or general requirements include:
220.127.116.11 Facilities and management of the agency,
18.104.22.168 Sufficiency and technical competency of personnel,
22.214.171.124 Suitability, calibration, and maintenance of equipment,
126.96.36.199 Quality system, audit, and review,
188.8.131.52 Responsibilities, duties, and authority of agencies,
184.108.40.206 Validity and appropriateness of sampling, testing, and inspection methods and procedures,
220.127.116.11 Management of records,
18.104.22.168 Reporting, review, and transmission of test and inspection data or findings, and
22.214.171.124 Specific requirements for identified fields (concrete, soil, etc.).
1.3 This specification can be used as a basis to assess an agency and is intended for use in accrediting agencies, public or private, engaged in inspection, testing, and Special Inspection of construction activities and materials used in construction. These services include but are not limited to reinforced concrete, precast concrete, structural steel erection, welding, bolting, soil and rock, foundations, masonry, sprayed fire-resistive materials, fire stops, exterior insulation and finish system (EIFS), and Special Cases. Building officials can use Specification to assess the competency of agencies in the fields covered by Specification .
1.4 A certificate of accreditation, including the scope of accreditation, is required to comply with this specification.
1.5 The users of an accredited agency must review the agency's scope of accreditation to ensure the agency has been accredited for its technical competence to perform the specific inspections or tests requested by the user.
1.6 This specification is not intended to:
(a) circumvent or replace the agreement between the agency and the owner that should clearly define the responsibilities and authorities of the agency;
(b) address design requirements that supersede applicable codes, laws, and regulations; or
(c) address construction means, methods, techniques, or sequences.
1.7 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
|Engelse titel||Standard Specification for Agencies Engaged in Construction Inspection, Testing, or Special Inspection|