Norm

ASTM E384-16

Standard Test Method for Microindentation Hardness of Materials

78,39

Over deze norm

Status Definitief
Aantal pagina's 28
Commissie E04.05
Gepubliceerd op 01-02-2016
Taal Engels

1.1 This test method covers determination of the microindentation hardness of materials.

1.2 This test method covers microindentation tests made with Knoop and Vickers indenters under test forces in the range from 9.8 × 10-3 to 9.8 N (1 to 1000 gf).

1.3 This test method includes an analysis of the possible sources of errors that can occur during microindentation testing and how these factors affect the precision, bias, repeatability, and reproducibility of test results.

1.4 Information pertaining to the requirements for direct verification and calibration of the testing machine and the requirements for the manufacture and calibration of Vickers and Knoop reference hardness test blocks are in Test Method E92.

Note 1: While Committee E04 is primarily concerned with metals, the test procedures described are applicable to other materials.

1.5 Units—The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Details

ICS-code 19.060
Nederlandse titel Standard Test Method for Microindentation Hardness of Materials
Engelse titel Standard Test Method for Microindentation Hardness of Materials

Winkelwagen

Subtotaal:

Ga naar winkelwagen