Norm

ASTM E517 - 18 en

Standard Test Method for Plastic Strain Ratio r for Sheet Metal

50,60 61,23 Incl BTW

Over deze norm

Status Definitief
Aantal pagina's 8
Gepubliceerd op 01-01-2018
Taal Engels

1.1 This test method covers special tension testing for the measurement of the plastic strain ratio, r, of sheet metal intended for deep-drawing applications.

1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Details

ICS-code 77.040.10
Nederlandse titel Standard Test Method for Plastic Strain Ratio r for Sheet Metal
Engelse titel Standard Test Method for Plastic Strain Ratio r for Sheet Metal
Vervangt

Winkelwagen

Subtotaal:

Ga naar winkelwagen