Norm

ASTM E520-08(2015)e1

Standard Practice for Describing Photomultiplier Detectors in Emission and Absorption Spectrometry

54,27

Over deze norm

Status Definitief
Aantal pagina's 6
Commissie E01.20
Gepubliceerd op 15-12-2015
Taal Engels

1.1 This practice covers photomultiplier properties that are essential to their judicious selection and use in emission and absorption spectrometry. Descriptions of these properties can be found in the following sections:

 

Section

Structural Features

4

 General

4.1

 External Structure

4.2

 Internal Structure

4.3

Electrical Properties

5

 General

5.1

 Optical-Electronic Characteristics of the Photocathode

5.2

 Current Amplification

5.3

 Signal Nature

5.4

 Dark Current

5.5

 Noise Nature

5.6

 Photomultiplier as a Component in an Electrical Circuit

5.7

Precautions and Problems

6

 General

6.1

 Fatigue and Hysteresis Effects

6.2

 Illumination of Photocathode

6.3

 Gas Leakage

6.4

Recommendations on Important Selection Criteria

7

1.2 Radiation in the frequency range common to analytical emission and absorption spectrometry is detected by photomultipliers presently to the exclusion of most other transducers. Detection limits, analytical sensitivity, and accuracy depend on the characteristics of these current-amplifying detectors as well as other factors in the system.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Details

ICS-code 17.180.30
Nederlandse titel Standard Practice for Describing Photomultiplier Detectors in Emission and Absorption Spectrometry
Engelse titel Standard Practice for Describing Photomultiplier Detectors in Emission and Absorption Spectrometry

Winkelwagen

Subtotaal:

Ga naar winkelwagen