Norm

ASTM E604-15

Standard Test Method for Dynamic Tear Testing of Metallic Materials

54,27

Over deze norm

Status Definitief
Aantal pagina's 9
Commissie E28.07
Gepubliceerd op 01-12-2015
Taal Engels

1.1 This test method covers the dynamic tear (DT) test using specimens that are 3/16 in. to 5/8 in. (5 mm to 16 mm) inclusive in thickness.

1.2 This test method is applicable to materials with a minimum thickness of 3/16 in. (5 mm).

1.3 The pressed-knife procedure described for sharpening the notch tip generally limits this test method to materials with a hardness level less than 36 HRC.

Note 1: The designation 36 HRC is a Rockwell hardness number of 36 on Rockwell C scale as defined in Test Methods E18.

1.4 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Details

ICS-code 77.040.10
Nederlandse titel Standard Test Method for Dynamic Tear Testing of Metallic Materials
Engelse titel Standard Test Method for Dynamic Tear Testing of Metallic Materials

Winkelwagen

Subtotaal:

Ga naar winkelwagen