Norm

ASTM E643-15

Standard Test Method for Ball Punch Deformation of Metallic Sheet Material

48,24

Over deze norm

Status Definitief
Aantal pagina's 4
Commissie E28.02
Gepubliceerd op 01-05-2015
Taal Engels

1.1 This test method covers the procedure for conducting the ball punch deformation test for metallic sheet materials intended for forming applications. The test applies to specimens with thicknesses between 0.008 and 0.080 in. (0.2 and 2.0 mm).

Note 1: The ball punch deformation test is intended to replace the Olsen cup test by standardizing many of the test parameters that previously have been left to the discretion of the testing laboratory.

Note 2: The modified Erichsen test has been standardized in Europe. The main differences between the ball punch deformation test and the Erichsen test are the diameters of the penetrator and the dies. Erichsen cup heights are given in SI units.

1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Details

ICS-code 77.040.10
Nederlandse titel Standard Test Method for Ball Punch Deformation of Metallic Sheet Material
Engelse titel Standard Test Method for Ball Punch Deformation of Metallic Sheet Material

Winkelwagen

Subtotaal:

Ga naar winkelwagen