Norm

ASTM E646 - 07e1 en

Standard Test Method for Tensile Strain-Hardening Exponents (n -Values) of Metallic Sheet Materials

  • Deze norm is ingetrokken sinds 15-11-2015

50,60 61,23 Incl BTW

Over deze norm

Status Ingetrokken
Aantal pagina's 8
Gepubliceerd op 01-12-2007
Taal Engels

1.1 This test method covers the determination of a strain-hardening exponent by tension testing of metallic sheet materials for which plastic-flow behavior obeys the power curve given in the Introduction.

Note 1A single power curve may not fit the entire stress-strain curve between yield and necking. If such is the case, more than one value of the strain-hardening exponent can be obtained (2).

1.2 This test method is for metallic sheet materials with thicknesses of at least 0.005 in. (0.13 mm) but not greater than 0.25 in. (6.4 mm).

1.3 The values stated in inch-pound units are to be regarded as the standard. The SI equivalents shown may be approximate.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Details

Engelse titel Standard Test Method for Tensile Strain-Hardening Exponents (n -Values) of Metallic Sheet Materials
Vervangt
Vervangen door

Winkelwagen

Subtotaal:

Ga naar winkelwagen