Norm

ASTM E646-16

Standard Test Method for Tensile Strain-Hardening Exponents (n -Values) of Metallic Sheet Materials

54,27

Over deze norm

Status Definitief
Aantal pagina's 9
Commissie E28.02
Gepubliceerd op 01-02-2016
Taal Engels

1.1 This test method covers the determination of a strain-hardening exponent by tension testing of metallic sheet materials for which plastic-flow behavior obeys the power curve given in the Introduction.

Note 1: A single power curve may not be a satisfactory fit to the entire stress-strain curve between yield and necking. If such is the case, more than one value of the strain-hardening exponent may be obtained (2) by agreement using this test method.

1.2 This test method is specifically for metallic sheet materials with thicknesses of at least 0.005 in. (0.13 mm) but not greater than 0.25 in. (6.4 mm). The method has successfully been and may be applied to other forms and thicknesses by agreement

1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

Note 2: The value of the strain-hardening exponent, n, has no units and is independent of the units used in its determination

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Details

ICS-code 77.140.50
Nederlandse titel Standard Test Method for Tensile Strain-Hardening Exponents (n -Values) of Metallic Sheet Materials
Engelse titel Standard Test Method for Tensile Strain-Hardening Exponents (n -Values) of Metallic Sheet Materials

Winkelwagen

Subtotaal:

Ga naar winkelwagen