Norm

ASTM E77-14e1

Standard Test Method for Inspection and Verification of Thermometers

56,20

Over deze norm

Status Definitief
Aantal pagina's 13
Commissie E20.05
Gepubliceerd op 01-05-2014
Taal Engels

1.1 This test method covers visual and dimensional inspection and test for scale accuracy to be used in the verification of liquid-in-glass thermometers as specified in Specifications E1 and E2251. However, these procedures may be applied to other liquid-in-glass thermometers.2

Note 1: The use of NIST SP250-232 is recommended.

1.2 Warning—Mercury has been designated by EPA and many state agencies as a hazardous material that can cause central nervous system, kidney and liver damage. Mercury, or its vapor, may be hazardous to health and corrosive to materials. Caution should be taken when handling mercury and mercury containing products. See the applicable product Material Safety Data Sheet (MSDS) for details and EPA’s website- http://www.epa.gov/mercury/faq.htm - for additional information. Users should be aware that selling mercury and/or mercury containing products into your state may be prohibited by state law.-

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Details

ICS-code 17.200.20
Nederlandse titel Standard Test Method for Inspection and Verification of Thermometers
Engelse titel Standard Test Method for Inspection and Verification of Thermometers

Winkelwagen

Subtotaal:

Ga naar winkelwagen