Norm

ASTM E790-15

Standard Test Method for Residual Moisture in Refuse-Derived Fuel Analysis Samples

48,24

Over deze norm

Status Definitief
Aantal pagina's 3
Commissie D34.03
Gepubliceerd op 01-09-2015
Taal Engels

1.1 This test method covers the measurement of residual moisture in refuse-derived fuel (RDF) analysis samples. It is used to calculate on a dry basis other determinations performed on analysis RDF samples. It is used with air-dry moisture results to calculate total moisture (Note 1). The total moisture is used to calculate as-received values or other analyses performed on a sample.

Note 1: In some instances RDF moisture may change during size-reduction steps of the RDF analysis sample preparation procedure. This moisture change, unless suitable corrections are made, will affect the accuracy of the total moisture value as calculated from the air-dry and residual moisture results.

1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For more specific precautionary information see Section 7.

Details

ICS-code 75.160.10
Nederlandse titel Standard Test Method for Residual Moisture in Refuse-Derived Fuel Analysis Samples
Engelse titel Standard Test Method for Residual Moisture in Refuse-Derived Fuel Analysis Samples

Winkelwagen

Subtotaal:

Ga naar winkelwagen