Norm

ASTM E831-14

Standard Test Method for Linear Thermal Expansion of Solid Materials by Thermomechanical Analysis

54,27

Over deze norm

Status Definitief
Aantal pagina's 5
Commissie E37.10
Gepubliceerd op 01-08-2014
Taal Engels

1.1 This test method determines the technical coefficient of linear thermal expansion of solid materials using thermomechanical analysis techniques.

1.2 This test method is applicable to solid materials that exhibit sufficient rigidity over the test temperature range such that the sensing probe does not produce indentation of the specimen.

1.3 The recommended lower limit of coefficient of linear thermal expansion measured with this test method is 5 μm/(m·°C). The test method may be used at lower (or negative) expansion levels with decreased accuracy and precision (see Section 11).

1.4 This test method is applicable to the temperature range from −120 to 900°C. The temperature range may be extended depending upon the instrumentation and calibration materials used.

1.5 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.6 This test method is related to ISO 11359-2 but is significantly different in technical detail.

1.7 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Details

ICS-code 19.060
Nederlandse titel Standard Test Method for Linear Thermal Expansion of Solid Materials by Thermomechanical Analysis
Engelse titel Standard Test Method for Linear Thermal Expansion of Solid Materials by Thermomechanical Analysis

Winkelwagen

Subtotaal:

Ga naar winkelwagen