Norm

ASTM E930-99(2015)

Standard Test Methods for Estimating the Largest Grain Observed in a Metallographic Section (ALA Grain Size)

54,27

Over deze norm

Status Definitief
Aantal pagina's 6
Commissie E04.08
Gepubliceerd op 01-10-2015
Taal Engels

1.1 These test methods describe simple manual procedures for measuring the size of the largest grain cross-section observed on a metallographically prepared plane section.

1.2 These test methods shall only be valid for microstructures containing outlier coarse grains, where their population is too sparse for grain size determination by Test Methods E112.

1.3 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Details

ICS-code 19.120
Nederlandse titel Standard Test Methods for Estimating the Largest Grain Observed in a Metallographic Section (ALA Grain Size)
Engelse titel Standard Test Methods for Estimating the Largest Grain Observed in a Metallographic Section (ALA Grain Size)

Winkelwagen

Subtotaal:

Ga naar winkelwagen