Norm

ASTM E953/E953M-08

Standard Test Method for Fusibility of Refuse-Derived Fuel (RDF) Ash

54,27

Over deze norm

Status Definitief
Aantal pagina's 5
Commissie D34.03
Gepubliceerd op 01-09-2008
Taal Engels

1.1 This test method covers the observation of the temperatures at which triangular pyramids (cones) prepared from RDF ash attain and pass through certain stages of fusing and flow when heated at a specific rate in controlled, mildly-reducing, and oxidizing atmospheres.

1.2 The test method is empirical, and strict observance of the requirements and conditions is necessary to obtain reproducible temperatures and enable different laboratories to obtain concordant results.

1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.4 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. See Section 6 for additional hazard information.

Details

ICS-code 75.160.10
Nederlandse titel Standard Test Method for Fusibility of Refuse-Derived Fuel (RDF) Ash
Engelse titel Standard Test Method for Fusibility of Refuse-Derived Fuel (RDF) Ash

Winkelwagen

Subtotaal:

Ga naar winkelwagen