Norm

ASTM E983-10

Standard Guide for Minimizing Unwanted Electron Beam Effects in Auger Electron Spectroscopy

48,24

Over deze norm

Status Definitief
Aantal pagina's 4
Commissie E42.03
Gepubliceerd op 01-11-2010
Taal Engels

1.1 This guide outlines the origins and manifestations of unwanted electron beam effects in Auger electron spectroscopy (AES).

1.2 Some general guidelines are provided concerning the electron beam parameters which are most likely to produce these effects and suggestions are offered on how to minimize them.

1.3 General classes of materials are identified which are most likely to exhibit unwanted electron beam effects. In addition, a tabulation of some specific materials which have been observed to undergo electron damage effects is provided.

1.4 A simple method is outlined for establishing the existence and extent of these effects during routine AES analysis.

1.5 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Details

ICS-code 17.180.30
Nederlandse titel Standard Guide for Minimizing Unwanted Electron Beam Effects in Auger Electron Spectroscopy
Engelse titel Standard Guide for Minimizing Unwanted Electron Beam Effects in Auger Electron Spectroscopy

Winkelwagen

Subtotaal:

Ga naar winkelwagen