ASTM F1145 - 05(2011) en

Standard Specification for Turnbuckles, Swaged, Welded, Forged

  • Deze norm is ingetrokken sinds 01-12-2017

50,60 61,23 Incl BTW

Over deze norm

Status Ingetrokken
Aantal pagina's 10
Gepubliceerd op 01-05-2011
Taal Engels

1.1 This specification covers swaged welded, cast, or forged turnbuckles with and without jam nuts.

1.2 A turnbuckle is an internally threaded loop or sleeve intended for assembly with a threaded stud, eye, hook, or jaw at each end, used for applying tension to rods, wire rope, and so forth.

1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.


ICS-code 21.060.70
Engelse titel Standard Specification for Turnbuckles, Swaged, Welded, Forged
Vervangen door



Ga naar winkelwagen